Customer Testimonials

"Great customer service. The folks at Novedge were super helpful in navigating a somewhat complicated order including software upgrades and serial numbers in various stages of inactivity. They were friendly and helpful throughout the process.."

Ruben Ruckmark

"Quick & very helpful. We have been using Novedge for years and are very happy with their quick service when we need to make a purchase and excellent support resolving any issues."

Will Woodson

"Scott is the best. He reminds me about subscriptions dates, guides me in the correct direction for updates. He always responds promptly to me. He is literally the reason I continue to work with Novedge and will do so in the future."

Edward Mchugh

"Calvin Lok is “the man”. After my purchase of Sketchup 2021, he called me and provided step-by-step instructions to ease me through difficulties I was having with the setup of my new software."

Mike Borzage

Have You Tried Refit Trim in Rhino 7?

December 08, 2021 1 min read

The RefitTrim command, new in Rhino 7, allows users, with high end surface modeling needs, to convert a trimmed surface into an untrimmed surface when possible.

This is an excellent starting point to create higher quality transitions between neighboring surfaces.
The new 4 edge NURBS patch is simplified and can then be used with any command for downstream surface creation. Check it out!